Hhaha I've had to drain and fill this trans enough times. They said I need a transmission range sensor, they could fix it. The manufacturer was not made aware of the defect. You also have to fill the fluid using this same hole. I have an 06' Forenza and my car has been doing the same exact thing as your car. I took it to a parts shop to see what the check engine was. Pour in a quart at a time and with your foot on the brake and car running shift the gears from park N, D 1,2,3, etc a few times.
It typically covers just the engine and transmission, along with any other moving parts that lead to the wheels, like the driveshaft and constant velocity joints. Has anyone changed the fluid in their manual transmission? The contact took the vehicle to a local mechanic for diagnostic testing and was advised by the mechanic that the transmission range sensor was faulty. It will still do it each time I accelerate so I have to be mindful to drive on the right side of the road so I can easily pull into a side road or driveway. Is this my transmission beginning to burn up or hopefully a simple fix that won't cost 3000 or more dollars to fix? Anytime I look up my make and model this is all anyone has to say and Suzuki will do nothing about it except charge more money to keep trying to fix it. The contact, who is an independent mechanic, stated that the vehicle was diagnosed that the range transmission sensor had failed and needed to be repaired. There is no drain plug, you have to unbolt the drain pan and have a bucket ready. Remove the pressure plate bolts and the pressure plate.
Then when you've determined the level, add at the appropriate area, check as needed. Jan 18, 2011 There is no dipstick for the forenza auto tranny. Do it incorrectly and you can damage the transmission. You must have the car running and warmed up to check it, shift through the gears, then put it back into park, remove the plug while running and fill to it comes out, then put the plug back in still running , and you should be good. Align the pressure plate and the clutch disc onto the flywheel using the clutch arbor J-42474. It's small, and it's held down bya 10mm bolt.
The vehicle was taken to an authorized dealer where the transmission range sensor was replaced. The contact stated that there was a clunking noise when changing gears. It's actually a problem under both seats. Remove the lower engine-to-transaxle bolts. Make sure you take it to an actual Suzuki Repair center, as my normal mechanic couldn't get it right, and I went through a few of them before I had it put on correctly. Suzuki needs to do a major recall!! Also, the airbag light turned on.
What is a Powertrain warranty? I received recall notice from Suzuki. Installation Install the transaxle into the vehicle. Not really that hard, especially for someone who's a mechanic anyways. Most of the time the dipstick and filling locations for an automatic transmission are fairly accessible near the top of the engine. Make sure you don't over fill so add it a little at a time.
By continuing to browse our site you agree to our use of data and cookies. The contact stated that while accelerating from a four way stop, the vehicle down shifted on its own and then shifted into neutral. The approximate failure mileage was 90,000. Unscrew it then check the level by finding if the fluid is to the hole. There might be a drain plug do not remove this one or you will have a mess. Apparently its my transmission range sensor and it has happened to a lot of people.
The vehicle was taken back to the dealer within an hour after the repair due to a recurrence of the failure and the sensor was reconnected. If you have leaks and are concerned about the level there is a fill plug. The contact was driving approximately 15-20 mph when he noticed that the gears were shifting independently. Raise vehicle on hoist, or jack up and secure with jackstands. Many thanks for stopping by at this website. They should be forced to recall all of these vehicles until the problem is resolved. Pressure Plate and Clutch Disc Removal and Installation Removal Disconnect the negative battery cable.
I drive a busy highway speed limit 65, I had to pull off the road so I would not get hit by a semi. . The vehicle was taken to a dealer who inspected the vehicle and advised that the transmission range sensor failed. Always add the additives first that way you don't have to gauge how much fluid to add, or have to drain some out in order to add the entire bottle. If youre looking for any new idea for your own parts diagram then the 2006 suzuki forenza manual transmission picture has to be on the top of guide or else you might use it for an optional thought.