On: Select this option to turn on Direct Power On. If you want to quickly view the content of pages found on the following pages of the manual, you can use them. Make sure the remote controller is within the allowable range when you operate it. Rotate the focus ring to focus. When this happens, use this setting to adjust the frequency manually. The image will reappear after some time, but it may be the wrong color or it may be accompanied by an error message. Do not try to send any other command to the projector.
Blackboard: Use this setting for easy viewing when projecting onto a blackboard. However, there is no guarantee that interference will not occur in a particular installation. If you want to quickly view the content of pages found on the following pages of the manual, you can use them. The currently selected menu item is the one that is highlighted. Also, any command that attempts to set a value that is outside the applicable allowable range will be ignored. Connecting the Projector to a Computer Connect the projector to the computer as shown in the illustration below.
All of the operations in this manual are explained using the remote controller that comes with the projector. Before cleaning the projector, be sure to unplug it from the power outlet and make sure it is cooled down completely. Aspect Ratio R C V H D Source Use this sub-menuto select an aspect ratio setting for the projected Specific image. When you have Direct Power On enabled, do not leave the projector plugged into an electrical outlet while it is turned off. If you forget your password.
E-14 To turn off the projector. Data Rate 19200bps Communication Data Bit 8bit Protocol Parity None Stop Bit 1bit Flow Control None Send this command when you want information about the current setup of the data projector. You can adjust the image width by using the remote control or the toggle of top of the projector. Just call us on 01189 070703. The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. . Theater: Use this setting to bring out the dark portions of your images.
The intensity of a color increases along with the setting value. Color: You can adjust the intensity of red, green, and blue within the range of —50to +50. Make sure the connected computer or is abnormal. Having your password cleared using the procedure described above will return all of the settings of your projector, except for the Light Time, to their initial factory defaults. Sub-menu The sub-menushows each individual setting under each main menu item, and its current setting.
Light error: Light source unit error occurred. Eco Mode Switches the Eco mode. Always turn off the projector and the video device before connecting them. This displays the input source selection screen. Remote Controller Signal Range When performing an operation on the remote controller, point it at the remote control signal receiver on the back or front of the projector. .
Plug the power cord back in and turn the projector back on again. Unpacking As you unpack the projector, check to make sure that all of the items listed below are present. Rear: Select this option to project from the back of the screen. Horizontal R C V Signal Use this sub-menuto adjust the horizontal position of the input Position Specific source image within the projection area. Microsoft, Windows, and Windows Vista are registered trademarks or trademarks of Microsoft Corporation in the United States and other countries. Note Depending on the pointer style you are using, the pointer may not display properly when you are using keystone correction.
Do not rub the eyes! This will change the volume setting accordingly. The projector contains a large number of high-voltagecomponents that create the risk of electric shock and burn injury. Description: This column provides details about the setting item and how to select it. If you normally wear glasses or contact lenses, you should be wearing them when you watch 3D images with the 3D glasses. Setting Unit: The setting unit indicates how a setting is stored. Never try to forcibly change the front foot position without pressing the release button.