Properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel. NATO Advanced Research Workshop on Properties and Applications of Nanocrystalline Alloys from Amorphous Precursors 2019-03-10

Properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel Rating: 8,2/10 155 reviews

Properties and Applications of Nanocrystalline Alloys from Amorphous Precursors : Bogdan Idzikowski : 9781402029639

properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel

The compounds are arranged according to the nonmetallic elements of the third, fourth, fifth, and sixth group of the periodic table. Milling device influences the microstructure and properties of final products. The ball-milled powder exhibited the highest dissolution rates and largest dislocation densities. Interesting phenomena of the physics of nanocrystalline materials are a consequence of the effects induced by the nanocrystalline structure. Presents the theory, related problems and applications in a highly detailed yet easy-to-read text, making this an ideal, understandable introduction to a complex topic. It was found that increasing the density of crystalline defects alters the solubility limit in these binary systems.

Next

Properties and applications of nanocrystalline alloys from amorphous precursors (eBook, 2005) [centroespagnol.eu]

properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel

The variation of structural and magnetic parameters reveals a strong dependence on the composition of Fe-Co-Si alloy. Chapter 1 is an introduction into some basic concepts, such as the definitions of basic magnetic quantities. The structural change and the resulting disorder are reflected in the changes in the lattice parameter and average magnetic moment of the powders milled for various time periods. Ristic et al: Magnetic Properties of Zr-3d Glassy Alloy Systems; J. Morphological observations indicate that the addition of Si to the alloys leads to finer particles.

Next

Properties and Applications of Nanocrystalline Alloys from Amorphous Precursors

properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel

Structural studies reveal that both NiO and NiO-Al powders exhibit face centered cubic structure with large crystal size reduction. The annealed alloys consist of nanoscale grains. Introduction to Dislocations is widely recognized as providing the essential knowledge base required for further study, research and technological application. The first edition of this classic academic reference was published in the 1960s when research on dislocations was intense and in the years since the book has carved its niche as a respected, reliable and understandable introduction to the subject area for students, graduates and researchers. Attention is also paid to the special character of the local atomic ordering and to the corresponding interatomic bonding as well as to anomalies and particularities of electron density distributions, and to the formation of metastable, nanocrystalline or quasi-crystalline phases built from exceptionally small grains with special properties. The evolution of the microstructure of the mixture iron and aluminium powders during the high energy mechanical alloying process was investigated by X-ray line profile analysis.

Next

Properties and Applications of Nanocrystalline Alloys from Amorphous Precursors

properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel

Scientific Affairs Division Publisher: Dordrecht ; London : Kluwer Academic Publishers, 2005. The results are compared with those of classical methods. The main focus of the papers is put on the new issues that emerge in the studies of nanocrystalline materials, and, in particular, on i new compositions of the alloys, ii properties of conventional nanocrystalline materials, iii modeling and simulations, iv preparation methods, v experimental techniques of measurements, and vi different modern applications. Although these powders have fine crystallites with size ranging around 9 nm, their coercivity is rather high, which depends strongly both on milling condition and composition. Description: 1 online resource xii, 456 pages : illustrations. The ferromagnetism of transition metal intermetallic compounds are covered by Booth.

Next

Some Aspects of the Crystallization of Finemet

properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel

The main focus of the papers is put on the new issues that emerge in the studies of nanocrystalline materials, and, in particular, on i new compositions of the alloys, ii properties of conventional nanocrystalline materials, iii modeling and simulations, iv preparation methods, v experimental techniques of measurements, and vi different modern applications. Fe80Nb7B12Cu1 and Fe80 NiZr 7B12Cu1, nanocrystalline alloys were synthesized in two high-energy ball milling devices planetary, shaker. Curie temperature of Fe-Si solid solution decreases gradually at a rate of 1. After 3 h of milling, the formation of two bcc solid solutions α-Fe1 Si, Cr and α-Fe2 Si, Cr is observed. The process of mechanical activation on the aluminothermic reduction allows for a controlled reduction of NiO and thus suitable for the applications in catalysis and ore reduction process. The lack of a physically sound model makes the interpretation of line broadening and the structure refinement procedure of Rietveld often difficult or even impossible. Three illustrative examples of severely deformed microcrystalline copper, the Rb3C60 f.

Next

Properties and Applications of Nanocrystalline Alloys from Amorphous Precursors

properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel

Crystalline grain size ranges between 9. For the present alloys, the addition of Cu is effective for the formation of nanoscale grains and the improvement of the soft magnetic properties. A coherent polycrystal model for the abnormal grain size dependence is presented. It is shown that expansion of the atomic size is caused by the formation of the localized moment. The thermomagnetic curves show a marked increase in magnetization above 850K corresponding to the crystallization of α-FeCo α-Fe phase in samples containing Co Mn. This book is a collection of articles on various aspects of metallic nanocrystalline materials, and an attempt to address this above need.

Next

Properties and applications of nanocrystalline alloys from amorphous precursors (eBook, 2005) [centroespagnol.eu]

properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel

Interesting phenomena of the physics of nanocrystalline materials are a consequence of the effects induced by the nanocrystalline structure. Curie temperature of Fe-Si solid solution decreases gradually at a rate of 1. Battezzati et al: Al-Rare Earth-Transition Metal Alloys: Fragility of Melts and Resistance to Crystallization; L. Uses minimal mathematics to make the subject more accessible and includes all-important, up-to-date references to essential further reading and research sources. A simple procedure for the experimental determination of C¯ has been worked out, enabling the determination of the character of the dislocations in terms of a simple parameter q. Magnetic Gibbs free energy; 3.

Next

Properties and applications of nanocrystalline alloys from amorphous precursors (eBook, 2005) [centroespagnol.eu]

properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel

The main focus of the papers is put on the new issues that emerge in the studies of nanocrystalline materials, and, in particular, on i new compositions of the alloys, ii properties of conventional nanocrystalline materials, iii modeling and simulations, iv preparation methods, v experimental techniques of measurements, and vi different modern applications. Thermomagnetic studies reveal the presence of different magnetic phases in the milled Fe-Si powders with high Si content, which depends on both composition and milling time. Herausgeber: Idzikowski, Bogdan, Švec, Peter, Miglierini, Marcel Eds. Another important focus of attention are new classes of materials which are not based on new compositions, but rather on the original and special crystalline structure in the nanoscale. Metallic magnetic and non-magnetic nanocrystalline materials have been known for over ten years but only recent developments in the research into those complex alloys and their metastable amorphous precursors have created a need to summarize the most important accomplishments in the field. The procedure makes the evaluation of particle size or coherent domain size, and the density and arrangement of dislocations rather simple with a high precision, especially in the case of untextured polycrystals or when dislocation population on the possible slip systems is uniform. Interaction of domain walls with defects; 6.

Next

Properties and Applications of Nanocrystalline Alloys from Amorphous Precursors

properties and applications of nanocrystalline alloys from amorphous precursors idzikowski bogdan vec peter miglierini marcel

Description Metallic magnetic and non-magnetic nanocrystalline materials have been known for over ten years but only recent developments in the research into those complex alloys and their metastable amorphous precursors have created a need to summarize the most important accomplishments in the field. A simple and straightforward procedure is presented for the rationalisation of anisotropic strain broadening in terms of the anisotropic contrast effect of dislocations or dislocation-like lattice defects. This work investigates the effects of 6. Tkatch et al: Kinetics of the Nonisothermal Primary Crystallization of Metallic Glasses: Nanocrystal Development in Fe Amorphous Alloy; S. Nanocrystalline Fe75Si25 powders were prepared by mechanical alloying in a planetary ball mill.

Next